Pass4sure 350-050 Question Answer

Which of the following are required components for Client MFP? (Choose two.) 

A. CCXv4
B. CCXv5
C. 802.11n
D. WPA2 w/TKIP or AES-CCMP
E. AnyConnect 3.0

Answer: B, D


Which of the following statements are true regarding RLDP? (Choose two) 

A. RLDP works only on APs configured in Open Authentication mode.
B. RLDP only works if the AP is in Monitor Mode.
C. RLDP will attempt to identify each Rogue AP only once.
D. RLDP only works if the Rogue AP is connected to a VLAN that is reachable by the WLC.
E. RLDP only works if the AP is in Local Mode.

Answer: A, D

350-050 Questions Answers 
350-001 Exams Dumps 
Cisco Exams Questions Dumps

Pass4sure 350-050 Question Answer

Which three security threats require the Cisco Adaptive wIPS service for mitigation? (Choose three.) 

A. on/off-channel rogue
B. spectrum intelligence
C. man-in-the-middle attack
D. rogue switch-port tracing
E. zero-day attack
F. network reconnaissance

Answer: C, E, F

Pass4sure 350-050 Question Answer

You have been hired to install an outdoor wireless network for a small city. The design must provide 360 degrees of coverage from a central location and at least 33 Mb/s of aggregate bandwidth for clause 18 radio clients. How do you design this solution? 

A. Three or more patch antennas installed in a circular pattern on the same supporting structure
B. One high-gain omni-directional antenna
C. Three or more parabolic dish antennas installed in a circular pattern on the same supporting structure
D. Three or more sector array antennas installed in a circular pattern on the same supporting structure
E. Three or more Yagi antennas installed in a circular pattern on the same supporting structure

Answer: D

Pass4sure 350-050 Question Answer

You are designing an autonomous wireless network for an office building that is located near a local airport. The customer requires the use of 802.11a/n clients only, and the APs must never change their channel after they are configured. Which two UNII bands and channels should you restrict the APs to use on the 5 GHz radios? (Choose two.) 

A. UNII-1 and UNII-3
B. UNII-1 and UNII-2 extended
C. 36-52 and 149-161
D. 36-48 and 100-140
E. 52-64 and 149-161
F. 36-48 and 149-161

Answer: A, F

Pass4sure 350-050 Question Answer

A clause 15 radio uses ___________ and supports data rates of ___________.

A. FHSS or DSSS, 1 Mb/s up to 11 Mb/s
B. DSSS, 1 Mb/s and 2 Mb/s
C. FHSS, 1 Mb/s and 2 Mb/s
D. DSSS, 1 Mb/s up to 11 Mb/s

Answer: B

_________ is classified as an 802.11i RSN with _________ as the mandatory encryption protocol.

A. WEP, TKIP
B. WPA2, TKIP
C. WPA, AES
D. WPA2, AES

Answer: D

Pass4sure 350-050 Question Answer

You are converting your wireless infrastructure from a data-only design to a location services design. Which task do you need to complete?

A. Disable the DSSS speeds for RFID compatibility.
B. Use fewer APs to avoid RFID 3D imaging.
C. Set APs to maximum power for RF fingerprinting.
D. Locate APs at the edges of your coverage area for trilateration.

Answer: D

Which statement about heat maps on Cisco WCS is true?

A. They are predictive and rely only on the accuracy of the information that is provided with the map.
B. They are based on real-time actual values if Cisco Compatible Extensions is enabled on the APs.
C. They are predictive but can be converted to real values by using the Refresh from network button.
D. They are based on real-time actual values because of fingerprinting.

Answer: A

Pass4sure 350-050 Question Answer

What does the letter P in the designation of the AIR-CAP3502P AP indicate?

A. The AP supports the new IEEE 802.11p (WAVE) wireless standard.
B. The AP requires professional installation.
C. The AP can be used in plenum applications.
D. The AP is compatible with polarization type antennae.

Answer: B